Look at areas of hair loss to determine what needs to be covered
In the first stages of hair loss, hair begins to fall off from the top of the head, is diffused, the amount of hair loss is very small, only the hair at the top of the hair seam is sparse. Most women at this stage of hair loss can use a hair topper with a smaller base size.
In the middle of the hair loss stage, the position of the hair seam on the top of the head shows a relatively obvious thinning state, and the amount of hair loss is large, at this time, medium or large base hair toppers can be used.
In the later stages of hair loss, there is usually a lot of hair loss, with a distinct baldness state, at this time you can use large-size hair toppers to cover, or consider using a full wig.
Measure the width and length of hair loss to determine what needs to be covered
Steps to measure hair loss areas
- Get a soft measuring tape and use it to measure the length of the widest point in your hair loss area from front to back and from left to right.
- Record the measurement and add an inch to each measurement to allow half an inch on each side of the base section of the hair toppers to easily attach the clip to the hair toppers.
- If the measurement is larger than the size indicated in our products, please ask a friend or family member to re-measure for you to confirm the accuracy of your measurement results. If the results of the re-measurement still show that the area of hair loss is larger than the area provided in the hair toppers, you may consider purchasing a full wig.
Steps to determine the hair toppers size
In general, when the width of the hair loss area is between 1 cm and 2 cm, you can choose a hair topper with a width of 5 cm to 7 cm.
If the width of the hair loss area is between 3 cm and 4 cm, you can choose a hair topper with a width of 8 cm to 9 cm. When the width of the hair loss area is between 5 cm and 6 cm, you can choose a hair topper with a width of 10 cm to 12 cm.
When the width of the hair loss area is between 7 cm and 8 cm, you can choose a hair topper with a width of 13 cm to 15 cm.
Measure the head circumference to determine the area to be covered
Steps to measure Head circumference
Make two measurements with a soft ruler against the scalp：
- Measurement for the first time, the forehead hair root and the occipital under 2 cm as two points, with a soft tape measure around one circle, and record the results.
- A second measurement to eyebrow bone and the occipital for two points, with a soft tape measure around one circle, record the measured results.
- Take the maximum value of the two measurements and the result is your head circumference.
Steps to determine the hair toppers size
The measurement results of the head circumference are in the range of 54 cm and below, and it is more natural to choose hair toppers in the range of 5 cm to 12 cm.
The measurement result of the head circumference is in the range of 55 cm to 57 cm, and the width of the hair toppers worn will be more comfortable in the range of 5 cm to 14 cm.
Head circumference measurements in 58 cm and above, within the scope of the hair toppers width within the scope of the 7 cm to 15 cm is more appropriate.
If you want to know more about us, please pay attention to the following channels：
- https://andriahair.com/
- [email protected]
- +86 132 1080 2367
Español 
English 
Deutsch 
Français